OL2408

 

OL2408 Analog Voltage Input Module

Inputs	8	Card Cage Power required	700mA
Input Type	0- 5 VDC or 0-10VDC	Conversion Type	Successive approximation
Resolution	14 bit  (1 in 16384)	Full Scale Calibration Error	± 15 counts max. ±  5 counts typical
Input Impedance	10Mohm	Offset Calibration error	± 2 counts max.
Maximum Voltage Input	± 15VDC	Max. Terminal wire gauge	18 AWG
Linearity error	± 1.25 count max	Terminal Strip	Plug In (removable)
Input stability	± 10 counts	Terminal Screws	Slotted (0.1" blade max.)
Type	17	Subtype	1

 

The OL2408 comes set up for 0-5VDC input range.  If you need 0-10VDC input range, you must remove the plastic module cover by lifting the board latches over the retainer hooks on the PC board.  Then, place the jumper on both pins of J2 and replace the plastic module cover.  To change back to 0-5VDC range, repeat the process and remove the jumper.  Having the cover over the range selector jumper ensures that it will not be inadvertantly changed.